Plaster03301
100 µW
- Joined
- Sep 5, 2016
- Messages
- 9
Hi I wanna swap my 350 watt hub motor for my 750 watt bafang almost look identical but a tad bigger so I could just swap guts of it. Question is my old 350 has a 9 pin wire from hub and the same to controller on the 750. It's a 3 prong cable connector coming from hub motor and one to controller is way different . Can I just cut the one going into controller and solder it to the right controller
Below is picture of 350 watt connectors and 750 watt ones. What's best way to go about this . I've posted on lunacycle and got nothing like always no one can seem to help me. I figured I could just cut the 750w one in pic with the many wires and cut the old 350 watt one that runs to controller and solder them together . Would that work? Hope to hear back thanks!
Below is picture of 350 watt connectors and 750 watt ones. What's best way to go about this . I've posted on lunacycle and got nothing like always no one can seem to help me. I figured I could just cut the 750w one in pic with the many wires and cut the old 350 watt one that runs to controller and solder them together . Would that work? Hope to hear back thanks!