Hi
Just got my first cycle analyst v3, wired it up to a generic Chinese controller and unfortunately made a silly mistake with the connector orientation when wiring the Dp connector to my controller.
I essentially wired the connector upside down, pin 1 actually was pin 6, pin 2 was pin 5, etc
Plugged it in for 2 seconds and realised my mistake, fixed the connector and now the cycle analyst boots up, speed, volts, watts, amps all seem to work fine however I can't seem to get the throttle to work. The throttle display on the main screen moves up and down fine. Also on the diagnostic screen the throttle in and throttle out display normal voltages within the range you would expect.
Connecting the throttle to the controller directly works fine. Is there a way I can check the output voltage on the throttle override wire coming from the cycle analyst with a multimeter?
Just got my first cycle analyst v3, wired it up to a generic Chinese controller and unfortunately made a silly mistake with the connector orientation when wiring the Dp connector to my controller.
I essentially wired the connector upside down, pin 1 actually was pin 6, pin 2 was pin 5, etc
Plugged it in for 2 seconds and realised my mistake, fixed the connector and now the cycle analyst boots up, speed, volts, watts, amps all seem to work fine however I can't seem to get the throttle to work. The throttle display on the main screen moves up and down fine. Also on the diagnostic screen the throttle in and throttle out display normal voltages within the range you would expect.
Connecting the throttle to the controller directly works fine. Is there a way I can check the output voltage on the throttle override wire coming from the cycle analyst with a multimeter?