Hello! I'm new but I'm really excited to be here! Been lurking this past month I finally built my first ebike with a used rear motor 36v 350w, a controller that came with the motor that is 36v 16a and two hoverboard batteries which I swap (one to get to work and one to come back home).
I noticed my voltmeter reading tension when I pedal and I'm wishing so bad for my no name controller to support regen, mainly for braking. I couldn't find anything about my controller online.
The display is connected to the positive power input on the controller
[*]
Here is a short video showing some action.
[
In the linked image there's the other connectors first one is orange and yellow (no ideia what it does), second and third are purple and yellow (are these the brakes?), forth is black and red(no idea), fifth is blue and black(no idea). I could measure the voltage output on each wire if it helps.
Thanks!
I noticed my voltmeter reading tension when I pedal and I'm wishing so bad for my no name controller to support regen, mainly for braking. I couldn't find anything about my controller online.
The display is connected to the positive power input on the controller
[*]
Here is a short video showing some action.
[
In the linked image there's the other connectors first one is orange and yellow (no ideia what it does), second and third are purple and yellow (are these the brakes?), forth is black and red(no idea), fifth is blue and black(no idea). I could measure the voltage output on each wire if it helps.
Thanks!