Recent content by big4x4

Gotcha. I'm curious though, why does the TVS diode on the ultra motor work just fine?

A diode will consume less than 5W so the loss is negligible. The problem is finding the correct place to put it. Flashing the system might work but doing the diode is only a few cents

You mean like a firmware flash? I thought they don’t have a 52v firmware

I made a mistake on my m600 motor purchase and got 43v setups instead of the 48v I ordered. :oops: Since so much time has passed (probably 9 months) and I already have all the batteries built for the two bikes I put together, I don’t have a way to get the 48v motors. Is there a way to run...

Over the last few months, I have purchased parts for 2 m600 builds since I sold my bafang ultra bikes. Had the frames, components, motor sitting but just got the 48V batteries in so started putting everything together. I finally had everything buttoned up and turned it on just to get an Error 07...

Has anyone tried the TVS diode on the CAN ultra motors? I tried on mine and it will not turn on the display. Any ideas?

Hello! I searched but didn't find any information about this topic. I am setting up a nucular controller but do not see anywhere to set a low voltage cutoff. I obviously do not want my bms to be in charge of that and just shut off while I am riding. I'd be amazed that a controller with this...

I got a new BBSHD and hooking it up to a cycle analyst v3/phaserunner setup. My old BBSHD setup went fine with the temp sensor in the V3 as a 10k thermistor but this new one definitely does not have a 10k. It seems Bafang is using a totally different thermistor all together. Before I start...

Hello There, I am wondering if anyone can point me in the right direction. Right now I have a 3500W Full Suspension bike from Hi-Power Cycles that I absolutely love, but I kind of have the urge to get a little bit crazier like some of you hotshots on here. Right now I am running on the...

I agree w/ Ypedal. I have been completely 100% satisfied with the bike, customer service, warranty, price, etc. Seems to be the recurring theme- Everyone who owns one is happy and satisfied, and those who don't are the loud mouths...

You guys are too funny. Yes, I am a real person. Yes, I am the actual owner of this bike. When I bought my bike, I was pretty excited so I asked for some pictures before they shipped it out. So, I would assume it probably was taken at their shop. It thought it was a great pic. A lot better...

OK, I have been reading the forums for a while now, and now it is time to break my silence and give my 2 cents worth. Ever since I started with a Synergy Cycle with a side mount BMC motor, I was hooked on electric bikes! I had been researching the internet relentlessly to see what direction I...

OK, thank you very much for your input. OK, and if I move away from 14S...What about charging with a lipo charger with no balance leads... Is there a BMS or individual balancers like a blinky that you can leave plugged into each individual battery's balancing tabs the whole time? Maybe with a...

Here is a question for you experts out there! I have four 7 cell lipo packs (25.9v Nominal) at 5Ah each. I have hooked them in series/parallel 2s2p to my bicycle at 51.2v 10Ah. I want to be able to charge it with one charging wire (pos. and neg.) and one balancing 7 pin connector. I want it as...

Well, I am ecstatic to report that one of my controllers works now with that wiring! The other controller still does not even budge but I am happy I have my bike working at least. Thank you everyone for your help and now I gotta think why this other controller is not working!