You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
-
-
C
Thank you
-
C
I discovered and not sure about is in the MqConn app it has “offset angle” which is set at 245 which I dont remember adjusting and...
-
C
Ok this morning I attached a jumper to the brake sensor wires with no brake levers attached and it showed the “unfamiliar fault” in the...
-
C
I did disconnect to test and fault still appeared.
-
C
The other thing is I tested both brake levers for continuity and they seem fine when I press on them and the multimeter shows they have...
-
C
Regardless of leaving the “fault” lever connected or unconnected and pressing on the lever that occasionally shows the fault when I...
-
C
12v when not pulled 0 when pulled on one lever and close to 1V when I pull on the other. When the lever I pull that shows 0 it pops up...
-
C
I am attaching screenshots of my BMS settings along with my controller settings. If someone can see that there are certain parameters...
-
C
No one has any input on this issue? Last thing I want to do is purchase a new controller and then find out later down the line it is a...
-
C
No settings were changed before these issues came up.
-
C
Problem not resolved even when I resoldered the wiring and reset controller. The issue is every time I applied brake I get “unrecognized...
-
C
I have 72150 Sabvoton and recently got the “unrecognized error” along with the e-brake not working when I press both levers. Brake...
-
Loading…
-
Loading…