Recent content by dirtgoon

I probably just need to step away from this thing for a while. I feel like a dumb shit but part of the problem was that I didn't have the throttle and brake sensor cables snapped into place like I thought I did. So I made sure they were fully seated and reflashed the 48v controller, the display...

Is there any way to undo OSF 20.1c.2 and put it back to factory settings after flashing it with the configurator? I may have wrecked two controllers trying to install the OSF, and possibly a display (I know I'm sure I'm the ONLY one this has ever happened to)

Well things have gone from bad to worse. I swapped in a brand new 36v 8pin controller and flashed it with the OSF. Throttle still didn't work and now it reads only one bar on the battery monitor (the battery is at 42v), no wheel speed and reads no other parameters when the light button is...

Yeah I did. Tried it several times, with RX and TX wires swapped and restarting the program, and restarting the display. Dave over at eco-cycles said they will program it for me free of charge!

Yes throttle in the center, brake sensors on the outside. Bit of a pain to get snapped into place.

I tried that several times. No matter what I do, it hangs on "waiting" indefinitely and the TX continues to count up while the RX stays at 0 counts (I have no idea what either of those values mean)

Cadence sensing is crap for mountain biking though

It's an 860c display like the title says, 850c was a typo.

Hello, I'm trying to program my 850c display with V20.1c.4 to match my motor that I just got done flashing. I followed the instructions on the eco-cycles site but it's not working for me. I made my own adapter and wired it according to the pictures. Is the attached diagram correct, TX to RX and...

It's a mixed bag of parts. I just thought any 8 pin controller would work since we're flashing it anyway. I happen to have another 36v 8pin controller that I might try.

It looks like the controller on the stealth hangs quite low for off road riding though. I think I would trash it in one ride with all the rocks here in Colorado. On the other hand, the X1 Pro looks to have the controller tucked up in there quite nicely.

I flashed the motor again with the temporary settings. My display only shows MPH when I push the lights button, nothing changes when I push the throttle. It's all brand new, controller, display, throttle, brake levers, everything. Only conclusion I can come to is that the combination of...

How would I check the throttle output voltage? Yes, the motor works correctly in PAS mode.

I have flashed my motor with the OSF for VLCD5 and can't figure out how to get the throttle working. I have a 48v motor with 36v battery, does anyone see any reason why it shouldn't be working? Thanks!

Do you have to use the supplied crankset or can you use your own? I'd rather have the ISIS interface for mountain riding.