Great to hear you improved your experience.
Do you get delay free response in CA-controlled throttle-modes?
As I said. The delay I'm talking about is independent from PAS. And seems to not be present in Thr%-PAS-mode.
Thanks.
The Delay for PAS is the same as for the CA-controlled throttle modes...
Pass throug/Bypass and (it seems) Thr% are free from delay.
There is no variable regen. Only the two configurable levels (Slide/Ebrake)
Thinking about it, the 2 level thing propably sounded much better than it is. Should propably just hook the rear brake to brake light+controller and find a reasonable Ebrake value.
Also, the delay in response to PAS is pretty bad in all modes. Except "thr%"-controlled it seems?
Did not manage to find smooth settings for that one yet... maybe after i adjust the curve in sabvoton...
My sabvoton is the basic model with only "slide recharge" (engages when throttle disengaged.) and regen braking (high lvl brake input).
Connecting one brake to the controller and the other to the CA I'm hoping to achieve 2 levels of Ebrake (while keeping the ability to "freewheel") by...
Has anyone tried this?
If i configure the voltage range of the throttle-out of the CA such that it always gives a tiny input - pulling the lever should still force it to 0V and activate "Slide recharge"?
did anyone find a solution to this? did the unlock several times, cutting power to controller in between but current limit reverts to default limit everytime.
@amberwolf
The 3 wires of the 6-pin connector that are connected are connected as described on the CA info page.
I do have a seperate shunt (came with the controller).
Here you can see the "SMY-6" Connector wich is wired exactly as described on the CA page.
And the "missing" lines seem to be as...
Found this one:
https://endless-sphere.com/forums/viewtopic.php?f=2&t=62809
So the missing wires are:
3. Shunt negative
4. Shunt positive
5. Hall sensor signal
Seems i didnt have to take it apart?
I've taken it apart and made some shots.
I hoped to see some solder where wires are missing. Sadly nothing.
Yellow and white not connected and one completely missing.
Hi.
I just ordered a CA3 for my 72080 but 3 of the six wires for the connector are not connected.
I think i saw a setailed description somewhere here but can't find it.
Can anybody please help me find out where to solder the wires?
I just bit the bullet on the CA3-DP and a 24P-PAS sensor. As i understand it i can just setup the default to PAS only mode and i just need to turn the bike off/on to start up in that mode.
What i didn't find out is how many amps its 12v line can provide.
And if i need to waterproof the thing...