Recent content by gogreenpower

Thanks, working on a tool now

Hi Guys, Any ideas on how to open up this motor? I don't have anything that fits those 4 cut outs around the freewheel threads, if that's it, then hammer and punch is my only option.

I can open the motor but I'll try the controller first, it's not my bike. It has a new type of Julet connector that I'm struggling to find, ever seen these?

The system was working one day and stopped the next. Just noticed the throttle doesn't work as expected. It used to push the bike to 6km/h without pedaling, now it's barely noticeable, does seem to work in combination with the pedal assist by providing a little boost. Controller is a KT36SVP...

Hi Guys, Anyone know what these are called?

It's a hub motor, Smartmotion is the brand. Brushless I assume. The speed displays when pushing the bike, as well as the throttle and pedal assist. The fault is common to all 3. Either the white wire from the hub or something in the controller?

Hi Guys, I have a problem with my display, whenever I use the throttle or pedal assist the speed displayed ranges from 0 to 70km/h, it goes up and down every few seconds. It's a generic controller/display combo. I believe the speed is being sensed through the motor as there is no external...

Everything I find doesn't have the recessed bearing

Hi guys, I know it's not specifically related to ebike's but it's for a trailer that will be pulled by my ebike. Anyway, I can't for the life of me find this type of hub online, does anyone know what type it is and if possible where can I get some. Thanks, Green

Why do some pictures post and others need to be downloaded?

So I have it all up and running, just tidying up a few little things before i call it complete. Here is a little mod I added yesterday in my minimalism quest. I still need to add an on/off switch, wired to one of the ebrakes or the LCD plug and get rid of the LCD. Green

After I had the battery sorted I fitted the BBSHD, I needed to file about 1mm off the BB outside where the rear suspension pivot point is welded on. Other than that installation was relatively straight forward.

Finally have it up and running. For stage one which I done second.. I built a 14S 5P battery from NCR18650GA'S and a bestech power H167 BMS. I did have a bit of difficulty with the BMS's, I brought 3 for the 3 batteries I have planned but 2 out of the 3 didn't work. Took...

Have a read of this https://www.google.com.au/amp/s/electricbike-blog.com/2015/06/26/a-hackers-guide-to-programming-the-bbs02/amp/?client=ms-android-telstra-au It explains things pretty well

I don't think there is a one click solution to disable it, but if you set all the PAS levels to 0, that should do the trick