Recent content by johnnyz383

Unbelievable!!...Of course you have never had an issue because you said yourself in the video you have a BMS installed. You say you charge at 20 amps?... "In addition we have a battery monitoring system....just to double check that every cell is in its SAFE range"...what a joke!.. So here is Rod...

LOL...I decided to go to 28 be cause 1) It turns the h4080 faster... 2) It gives me more range... 3) It's less stressful on all the batteries..4) Gives more torque and speed...AND!!..I have the room in the battery box neatly tucked away under the seat.. However, noone talked about the little...

Ok not sure what this means.... ive decided to go with evpower's individual bms units that shunt the voltage to whatever cell goes beyond 3.6 volts... I have 28 headways and so need 28 of these lovelies....Once i get the lot balanced up with the weak RC charger( I can do six at a time) ( Imax...

Ok...I have found a couple of BMS's.. One at EV essemble....a 24 S Capacitor based balancing BMS at $139.00 One at Besttec power co. a 24 S bleeding cell BMS and quoted me $174.00 One at BMSbattery a 24 S Bleeding based BMS and is $95.00 Does anyone have any information or experience...

Thanks for the info...what I was hoping was for someone to respond with a good BMS and experience to go along with it. The expensive one you mentioned is over $400.00 and the other is $95.00...big difference in price...one is unrealistic and the other might not be very good... John

Thanks, but that is not accurate. There are of course 28 series BMS's you can buy but since I dont have time to scrounge the internet for reliable and well made yet affordable BMS's I put out this question for others on here in case someone is aware of anything different. It does seem that you...

According to a knowledgeable source, Yellow-Red Green-Green Black-Yellow I'll post when I try it out. John

Ok I was getting the female and male connectors mixed up...ok so the reader who verified the pin out on the throttle side was correct, red=5v, yellow=ground,green=throttle signal, but not on the controller...I think that the black on the controller side is ground, guessing that green is the...

Ok well you told me that whats left over is the throttle...in this case a 3 pin female connector, but its not the connector im interested in but the 3 wires connected to it and their designation ;) John

well, lol we cant have that then can we?....someone will know which wires to hook up on the controller side to the throttle side... No I didnt get em confused...look more closely at the diagram....the "?" mean I dont know what it's designation is John

Thanks for that but the connector I cut had a seperate sleeve on it labelled "throttle"...here are the rest of the connectors and instructions on the back of the controller...

Thats the throttle your talking about?....yes I could hook up the controller and see what is what but I have the throttle and controller in a different place then the rest of the trike and wanted to solder connections to both before hooking up to the rest of the trike. Need to know the wires for...

Ok...just got a 18 Fet crystalyte controller and didnt have the right plug for the crystalyte throttle, so stripped each only to find these color wires (which dont match)....anybody know which is the power and which is the ground and 5 V for each so I can match them up?? Thanks John

Im looking into these motors. You mentioned that they are cheap. Where did you find them>...any local distributors or just from china? John

What...me cheat??...I have pedals up front and I will be pedalling.... ;)