Recent content by medusa569

Well after 5 months it's finally running !!! Hallefrickinlujah. Apparently for this kit 36/48 volt 500W The whole problem is the wiring for the throtlle and the controller setup. I‌ used the included twist throttle which I may alter or switch out in the future but for now I just hope there is...

Yes the switch is turned on as evidenxed by display.

Followup...sucessfully connected 5 wire twist throttle so at least I know that I‌ was able to achieve display and battery voltage. However the motor showed no signs of life. It may have something to do with the white wire that has no mate. Onother site identified white hall sensor wire as a temp...

Hey Tommy! I'm finally checking in again as I laid out my components on a work board, changed some connectors etc. I finally found the supplied twist throttle to see if something was missing would recitify itself with the 6 wired throttle. Well...nothing changed. No power showing on throttle...

Yes the first pic IS what I have. Let you know how it goes.

Hey tc: So when you say jump the power wire its as I described...basically joing tother the red postive power and the yell throtte wire together than then add on connector for battery connection? I don't know what green wire you are referring to. I‌am NOT uing the 6 wire throttle as it is a...

Well I‌tried again today first 3 wires standard for throttle connected and the final yellow throttle wire I attached to the burgundy/brown wire on controller throttle connector. Still no luck... It seems as if something needs to be done with the remaining 2 controller throttle wires.....Do I‌...

First my controller does not have the same wiring as your diagram. There is no electric lock nor a blue wire on the throttle. Throttle has red,black,green and yellow. Secondly my controller is rated 36/48 volt. Thirdly do you mean that the yellow should be connected to the large red power wire...

sure

OK since I couldn't figure out the 6 wire throttle I bought a 4wire throttle ( 3 + yellow power wire for LED) . Is the yellow for throttle high voltage or low? I see by some videos it says to connect straight to battery but I can't figure out how to do that unless i connect the throttle yellow...

Yea I opened it up and saw no other extra wire. If I‌ had installed it the way the kit supplier sold it the 6 wire throttle connection does have a power wire that would allow te led readouyt to function but then that still wouldn't be the power up for the controller I think. I‌ would think...

I'm trying to follow the KISS formula. I‌ only wanted to be assured that the controller had power when connected to a battery. I‌ didn't want to test the whole setup. I've read that most of the chinese cheapies have no thin red wire for ignition. The higher priced ones WILL have it. The one...

Since I am having to mix and match items that are not in "kit" I'd like to simplistically test the controller without my full fledged battery. I've already fried the connectors of 1 controller twice. Scarey. I'd like to use a minor power source so a psu power source (‌maybe at 12 volt) to see...

A misunderstanding.. I‌was attempting to ride this Powerless. No phases , no nothing. Yes I chcecks the brakes as that would be an obvious thing. I‌did remount it and I‌ suspect that it may have something to do with that. I‌was under the impression and after researching that there must be some...