I have seen epic levels of dangerous riding over the last few years.
I guess its a phase..no pun intended..we are going through.
Middle aged men on 60 mph scooters overtaking traffic to get more beer from the shop, wearing shorts and no helmet.
13yr olds on direct hub converted bikes doing...
Buy a pedal assist mid drive with fault codes, rip out the controller and wire up the phase wires to a 1000w sensorless controller, most will run fine.
If you have problems you could go all techy and glue your own halls to it.
that disaster of a pack looks like an art class used up extra art casting supplies they had laying around trying to get some of it to land on the battery.
😂
Its all the interconnecting wires that are soldered to the tabs, crossing over each other.
I tried to break it apart because a wire pulled out and the voltage dropped, no idea what the problem was.
I diagnosed it by stopping the hub under power out of its casing, bit crazy, but survived it.
Is there a reliable fix.
Its a 350w version I ran at 2500w, everything survived except the glue?
https://youtu.be/bdXpTmna600
A geared bafang hub, no halls connected.
I had to swap phase wires to get it back to normal.
What was the controller doing?
https://youtu.be/ryIgRGBMl38