Recent content by pagaille

Hi, Since I replaced my inner hall sensor (the one inside the motor itself), I noticed the following behaviours : - Motor works perfectly but max power is limited to 420W, EXCEPT when cadence is > 80 where the power brutally jumps up to 700W. - Walk assist doesn't work correctly. The motor is...

I fixed it. See my howto if you ever need to repair you motor inner hall sensor. --> https://endless-sphere.com/forums/viewtopic.php?f=30&t=107538&p=1574314#p1575968

FIXED ! So, being of out luck finding the replacement hall sensor assembly, I tried to fix it. Actually it wasn't so difficult. It requires some good soldering skills, lot of flux, desoldering braid, a desoldering pump, and a fine tip for your soldering iron. Here is my repair guide ! The...

Thanks @casainho. Turns out one of the inner hall sensors is not working anymore. Finding the assembly as a spare part looks difficult. Anybody having a fried motor with working hall sensors wanting to sell it to me ?

Update. Found the hall sensors that are actually mounted just beside the screw power terminals behind a black silicon paste. Here are some pictures. I tried to resolder the joints without success. That PCB is really small and looks glued to the plastic support. Chances are that any...

So the hall sensor has indeed a problem. I tested using the method provided on this thread : https://endless-sphere.com/forums/viewtopic.php?f=3&t=105444&p=1543436&hilit=led+hall#p1543566 With the sensor connected to the controller I measure voltages either 0 V or +5V between the black...

This is how it appears : https://nextcloud.gaillet.be/index.php/s/WYjSfq47M2Jy27t

Spot on. The display shows somewhat random numbers between 5 and 7. Sometimes 4 appears too. Let’s dismantle it to understand what’s wrong. Thanks !

I measure 2,7 ohms. I guess the sensor is electrically ok. Thanks anyway.

Nice tip. Let me check.

Sure, but that’s a somewhat tedious task. Maybe there will be other ideas before I try that ?

Hi guys, My TSDZ2 is dead 🙁. I opened a separate thread, maybe you could help me diagnosing why my motor suddenly doesn't work anymore after adding a temperature sensor ? (Display oddly shows : Error 3 : Torque Fault) Would you be kind enough to have a look at it ...

UPDATE : I fixed it ! See below my howto (https://endless-sphere.com/forums/viewtopic.php?f=30&t=107538&p=1574314#p1575968) to fix the motor inner hall sensor. Hi, I need help to understand what's wrong with my motor who died during a maintenance. 🙁 It's a TSDZ2 running the...

GREAT ! Let's try 😊

Thanks @casainho ! Did you manage to solve the most obvious issues for that 1.0 release ? * auto power off not working (just found my battery completely depleted this morning) * SW102 lockup issues in configuration mode - calibration impossible * power cut-offs on bumps with default...