Recent content by TerrySavace

Cant find anywhere on the web the part number, any help is appreciated. It looks to be a qs205 or qs273 3.5T , however do the numbers mean anything more to you? I know there are a few different versions Thanks in advanced! NC200928 0706 3.5T

Hi all, I have a battery and the balance connectors are not long enough to reach my BMS. its 22S - does anyone know the name of the connector types that ANT BMS uses for balance wires? Or where i can get some cable extenders? Also if you know the name of the little connector at the bottom in...

May i just thank you for your time on writing all of this out - its been VERY helpful!

Thanks, will grab one of these!

Thanks for your reply. Its a 22s14p sony VT6 battery, powering a qs205 motor via a nucular electronics 24f controller. I want to be able to check cells and provide protection to the bike - hence will use an ANT controller

Hi all, Just wondering if you have any suggestions on what BMS to use for a 22s14p sony VT6 setup. I see a lot of 22s BMS's only have 100Am discharge? Do ant do one? Thanks in advanced! Terry

Is the adaptto still for sale?

Josh, i have one of these, need new bushes , do you happen to know the size?? Terry

Does anyone have a 14kw adaptto controller they want to sell? Thanks Terry

Have contacted lighting rods, he has said that he is unsure if the motor will run as its not been tested before.... I guess a question I have is - is it possible for an ESC that has been configured to run one motor, run another with no configuration update, if the other motor is close enough to...

Hi all, I need a Kuberg Freerider Motor however brand new they are 1k, and impossible to find used. Anyone know of any other motor that will just "work" with an existing 12kw controller? Dont really want to replace the controller so i guess a replacement non OEM motor would have to be near...

Does any one have a Kuberg Freerider motor spare, either used or new and would be willing to sell it? many thanks Terry

Also i noticed you replaced the bearings previously, which brand did you use? Do you know what spacers are used? Mine are a bit rusty for some reason and I want to replace them! Thanks again Terry

Thanks for the case sizes - I have a used freeride i have purchased, not in great condition and a few parts need replacing. Debating building my own battery also to increase range so need a case, its possible I could just have a spare battery and make the battery easily swappable. Where are you...

Hi all, Just got myself a used 12kw Freerider, need to replace some parts on it, does any one know where i can source spares in the UK? I have found a site that has what i need but they dont ship to the UK :( Below is what i need, probably over priced and could possible source some of the...