Theodore Voltaire

I'm now thinking of 2 ways of building a 72v pack that would fit my space. Plan a 7 parallels of groups of 20 cells in series = 72v...

I see what you mean. According to the chart 0.15 x 8 is only equivalent to 7g wire. 0.3 is like 14g. 14g seems small for 20 amps? Maybe...

This may be hard to visualize, but this is what first came to mind. This would be 1 parallel, of 7. 20 cells welded in series, folded...

I hope that's not what's left of Bullwinkle.

This depends on your pack layout. Perhaps you can draw it, or at least describe it? I just skimmed through the thread quickly, so...

I'm in the process of ordering supplies. Heat tape, Fish paper, plastic cell holders. The welder is expected near the end of the month...

The front mount is the easiest part

You've probably noticed there's very little aftermarket for Stealth's. You have to think outside the box a little bit to customize one...

Look what I found today during my (almost) daily sunset ride in the woods.

These are the ones I have on my bike. I have 24 x 65 mm DW https://www.robsson.de/en/wide-rims/36-spoke-holes/double-wall-rims/24-rim-size/

Looks like even with the holders, 5 cells will easily fit across my frame, and there's more than enough room for 2 layers high, and 7...

Restoration finished Frame sandblasted and galvanized, painted with steel-it Motor qs205 4t Controller nuc24f

They were formally from Electra Bikes, but Trek sells them now...

Yesterday I ordered one of these BMS, and a K Welder. A 100 amp BMS is the biggest one of these that will fit in my frame so that's...