Search results

Date Relevance Most replies

  1. T

    Display wiring

    Great, thanks, d8evh. Then I have some thing to check. Rx and tx. The yellow is the far right,(P3) because it is the only wire that are cut og and There are some wire on the pad.
  2. T

    Display wiring

    Hi, I have tryed to have this post in E scooter but have no reply. So I think I will try here. A friend have this Denver E scooter and he manage to pull out the cable from the display. I want to hjelp him resolder the display wires. There are 6 wires to solder. The blue one are just going to a...
  3. T

    Tsdz2 firmware open source adapted to vlcd5, vlcd6 and xh18

    Hi, I have read all post and are still comfused whitch firmware I should try. I want ny fatbike to be street legal for Norway. Max speed 25kmh. 250w nominal. That means that it can have more watt for å short time, but if it runs continuous With more than 250w in 1 hour it can be overheated or...
  4. T

    Denver display wiring

    Hi, I have a friend that have this Denver E scooter and he manage to pull out the cable from the display. I want to hjelp him resolder the display wires. There are 6 wires to solder. The blue one are just going to a blind connector. I hope that there are someone who can hjelp me with a photo or...
  5. T

    Modding trottle signal

    Ok, Thanks for good reply. So far I have disconnect/cut the green wire, made it go through some switches so I can turn it off and the trottle will not work when pedaling on public roads. Next controller will be with 6kmh wires and the all the other stuff that needed for get the most out of the...
  6. T

    Modding trottle signal

    So if I understand the trottle in low possision gives 4 V and with full aprox 0 V. Can I then take a switch and a variable resistor/pot wired in serial, then parallell to the red and green wire on trottle. (I also have working pas on 4 the bike with speed limit 25kmh KT36ZWS controller)
  7. T

    Modding trottle signal

    Hi, I have purcased a e bike kit with a normal trottle with 3 wires. I want to make it as a 6kmh limit trottle. Can I put a variable resistor in serial on 5V red wire to on the trottle to get the speed limit down to 6kmh ?
  8. T

    Need a New 250W 36V controller

    Thanks for good replyes. it is important that the controller normaly only gives max 250W and only gives boost for a short time using trottle or tumb switch or lcd panel switch. That is the only way I can get it street legal, includ 25kmh speed limit and pas. Over 6kmh the hub motor has to stop...
  9. T

    Need a New 250W 36V controller

    Thanks for reply. This controller will work like my old one, it vil not give me a boost, or am I wrong?
  10. T

    Need a New 250W 36V controller

    Hi I am from norway and new on this forum. I have lot on net and could not find the right noe in the jungel of controller s. I have a old ebike ( Liberty Electric 443 mountain) and the controller has blown. (Wzkd3615ka-hd4 brushless intellect 1:1 controller) the bike has trottle, motor brake...
Back
Top