wallstreet
1 µW
So, I got 30H error code on my Bafang, I run a 500C display. Display shuts down immediately after turning it on, on two different batteries, a downtube and a rear rack battery. When the power button is held on, it reads 30H error code and 7-8 volts on the battery.
Before this, I noticed the motor would not supply power via PAS or throttle. Also heard a clicking when pedaling but not when I had the throttle.
So, I got a new display and a new controller, installed both, same problem. Currently waiting on a new 1t4 cable. Brake sensor also does not activate when I have the power button pressed.
During install of the new controller I noticed a few drops of water leaking out from a gasket within the controller compartment.
Any advice?
Before this, I noticed the motor would not supply power via PAS or throttle. Also heard a clicking when pedaling but not when I had the throttle.
So, I got a new display and a new controller, installed both, same problem. Currently waiting on a new 1t4 cable. Brake sensor also does not activate when I have the power button pressed.
During install of the new controller I noticed a few drops of water leaking out from a gasket within the controller compartment.
Any advice?