Hello.
I have a Bestech BMS HS-006 board and I use it for a 12 cell lipo. problem is that after a few hours of discharge the cells are severely out of balance. where the difference between min and max voltage reaches 700 mv. Now in the setup software it is possible to make the BMS disconnect the battery when the difference reaches 1000mv but I don't know what to modify so that the BMS will start balancing since apparently it doesn't. The Bestech representatives are super unhelpful with this and even won't provide a manual for their software so I would appreciate if anyone had any suggestions.
I am adding a picture of the setup software.
I have a Bestech BMS HS-006 board and I use it for a 12 cell lipo. problem is that after a few hours of discharge the cells are severely out of balance. where the difference between min and max voltage reaches 700 mv. Now in the setup software it is possible to make the BMS disconnect the battery when the difference reaches 1000mv but I don't know what to modify so that the BMS will start balancing since apparently it doesn't. The Bestech representatives are super unhelpful with this and even won't provide a manual for their software so I would appreciate if anyone had any suggestions.
I am adding a picture of the setup software.