NeilP
1 GW
Hi
After many years...(Since the Xlyte 540x group buy) I am finally getting around to putting the bike together..
Have an old V2.23 CA and a lyen EB224 Controller.
Going to run at ..34-35 series lipo...147 volts.
No other accessories..just the CA and a throttle
Can I run the CA at 150 volts direct from the controller ? or am I going to need a separate PSU for the CA ?
Just found I need to set the CA Advance setup to high range to take the low shunt resistance of the EB224 in to account done the iCharge calibration method and it gets me 0.682mOhm...seems the CA only goes down to 0.763 in Low range.
But the voltage thing...
Cant even remember where I'd look it has been so long doing this stuff.
After many years...(Since the Xlyte 540x group buy) I am finally getting around to putting the bike together..
Have an old V2.23 CA and a lyen EB224 Controller.
Going to run at ..34-35 series lipo...147 volts.
No other accessories..just the CA and a throttle
Can I run the CA at 150 volts direct from the controller ? or am I going to need a separate PSU for the CA ?
Just found I need to set the CA Advance setup to high range to take the low shunt resistance of the EB224 in to account done the iCharge calibration method and it gets me 0.682mOhm...seems the CA only goes down to 0.763 in Low range.
But the voltage thing...
Cant even remember where I'd look it has been so long doing this stuff.