Millhouse_5
1 W
- Joined
- Nov 27, 2020
- Messages
- 62
Good evening everyone.
I'm a bit new to the ebike scene and I'm trying to squeeze a little extra top end out of my proton GTS.
I've heard that the shunt mod is the way to go to get what I'm after but my first attempt yielded literally zero results I've come looking for some more advice.
The controller has 4 shunt wires and space for a 5th, so I took some 14awg solid wire and soldered it in the empty place but didn't get anything more when I propped it up on a stand and went full throttle.
should my next step be just throwing solder on and wrapping wire around the current shunts to get as much metal on there as possible?
Here is the shunt configuration. This is the picture before I added the extra wire in the middle
I'm a bit new to the ebike scene and I'm trying to squeeze a little extra top end out of my proton GTS.
I've heard that the shunt mod is the way to go to get what I'm after but my first attempt yielded literally zero results I've come looking for some more advice.
The controller has 4 shunt wires and space for a 5th, so I took some 14awg solid wire and soldered it in the empty place but didn't get anything more when I propped it up on a stand and went full throttle.
should my next step be just throwing solder on and wrapping wire around the current shunts to get as much metal on there as possible?
Here is the shunt configuration. This is the picture before I added the extra wire in the middle