Cannon5610
10 µW
- Joined
- May 8, 2015
- Messages
- 5
I have a baja be 500 with a 48v controller and a 500w hub motor. I added in another battery and the bike worked great afte a few weeks I got greedy and added another battery in to make it 72v. I drove the bike a few blocks and fried the controller. I went to an ebike shop and told the owner what I had done. He suggested I buy a 72v brushless daymak drive controller. Now obviously it will be different wiring then the original controller. I have figured everything out except the hall sensor and phase wires. I haven't hooked the battery up to the bike for fear of blowing something up. With the original controller as long as the phase wires were connected correctly the tire would spin freely but with this new controller every phase wire combination I have tried has not worked. The motor feels like the break grabs every couple seconds. This is the same with every combination.
Any suggestions would be helpful.
St Thomas Ontario Canada.
Any suggestions would be helpful.
St Thomas Ontario Canada.