Hi
I'm planning on a project and I got the Roboteq dual motor controller. 60v 75amp each motor
But it turned out works only with hall sensor motors.
So I would like some help on how to setup hall sensors in a outrunner.
I got the e0design hall sensor adapter but their is no data on them. I sent them a message but still no reply.
Can't I place them internally? If how to?
I have rimfire 160kv and scorpion 250kv
The breakout board of Roboteq has "grd, +5,A,B,C"
I need 3 sensors, 1 must be between 2 magnets and the other 2 exactly on magnets. Right?
I saw http://alienpowersystem.com/product-category/brushless-motors/80mm/
Did any1 try these motors ?
Btw is it possible to run a hall sensored outrunner dipped in thin oil?
Thank you
I'm planning on a project and I got the Roboteq dual motor controller. 60v 75amp each motor
But it turned out works only with hall sensor motors.
So I would like some help on how to setup hall sensors in a outrunner.
I got the e0design hall sensor adapter but their is no data on them. I sent them a message but still no reply.
Can't I place them internally? If how to?
I have rimfire 160kv and scorpion 250kv
The breakout board of Roboteq has "grd, +5,A,B,C"
I need 3 sensors, 1 must be between 2 magnets and the other 2 exactly on magnets. Right?
I saw http://alienpowersystem.com/product-category/brushless-motors/80mm/
Did any1 try these motors ?
Btw is it possible to run a hall sensored outrunner dipped in thin oil?
Thank you