steviechaplin
1 µW
- Joined
- Dec 20, 2020
- Messages
- 2
Hi all
Hope you are all well.
I am after some help with wiring my electric scooter up. I got it non running and just require some technical help on the final bit so i have the following
(Controller wiring)
Green - TX
Blue - RX
Black - GND
Red - +
Yellow - SW
(Dash wiring)
Green - TX
Blue - RX
Black - GND
Red - +
Yellow - Key
(Controller motor wiring)
Red - +
Yellow - Hall B
Blue - Hall A
Green - Hall C
Black - GND
(Motor Wiring)
Red - +
Blue - Hall B
Yellow - Hall A
Green - Hall C
Black - GND
I have opened up the motor and checked the hall color cables and correct.
When i try and power the scooter up via push button switch the dash will light up but as soon as i remove my finger from the power button it turns straight off.
Any help would be greatly appreciated
Many thanks
Steve
Hope you are all well.
I am after some help with wiring my electric scooter up. I got it non running and just require some technical help on the final bit so i have the following
(Controller wiring)
Green - TX
Blue - RX
Black - GND
Red - +
Yellow - SW
(Dash wiring)
Green - TX
Blue - RX
Black - GND
Red - +
Yellow - Key
(Controller motor wiring)
Red - +
Yellow - Hall B
Blue - Hall A
Green - Hall C
Black - GND
(Motor Wiring)
Red - +
Blue - Hall B
Yellow - Hall A
Green - Hall C
Black - GND
I have opened up the motor and checked the hall color cables and correct.
When i try and power the scooter up via push button switch the dash will light up but as soon as i remove my finger from the power button it turns straight off.
Any help would be greatly appreciated
Many thanks
Steve