Bobby June
1 W
I had to disassemble the harness encasing and separate all of the wires so that I can lower the profile of the entire FarDriver controller.
I made fairly good notes on each wire however, on some flame-based work, I burned some of the masking tape labels I applied to certain wires.
yay!
I’ve tried to look really hard on the web, but I just cannot find a description for my particular controller as to which wire goes where. I’ve asked SIA for a diagram, but they haven’t gotten back to me.
I find diagrams for Fardrivers but it’s for a different model and I’m sure the wires are different
Any idea what I should do? And is there any concern about these wires creating a catastrophe that I’m not aware of if I hooked them up incorrectly or maybe better said, is there any specific wire that is definitely a NoNo when trying to move it around to test? I’ve got the orange ignition wire placed.
I’ve got to take better notes. This is stupid.
I made fairly good notes on each wire however, on some flame-based work, I burned some of the masking tape labels I applied to certain wires.
yay!
I’ve tried to look really hard on the web, but I just cannot find a description for my particular controller as to which wire goes where. I’ve asked SIA for a diagram, but they haven’t gotten back to me.
I find diagrams for Fardrivers but it’s for a different model and I’m sure the wires are different
Any idea what I should do? And is there any concern about these wires creating a catastrophe that I’m not aware of if I hooked them up incorrectly or maybe better said, is there any specific wire that is definitely a NoNo when trying to move it around to test? I’ve got the orange ignition wire placed.
I’ve got to take better notes. This is stupid.