MartyMcfly1
10 mW
- Joined
- Jan 16, 2021
- Messages
- 20
Looking for some advice regarding parallel li-po
I'm currently running my bike with 22s li-po in series, Sabvoton 72150 controller and Grin Cycle Analyst V3.
Current set-up I'm using Turnigy 10ah li-po packs, three 6s packs and one 4s pack. They're rated 12-24c discharge.
I have some Tattu li-po packs spare which are 10ah, same size packs, three 6s and one 4s. These are rated at 25c discharge.
My question is, would I be okay to connect these different brand packs in parallel, so I'd be running same voltage etc but with 20ah capacity? The reason I'm unsure is because they're different brand packs and I'm assuming have a slightly different internal resistance.
Any feedback appreciated.
I'm currently running my bike with 22s li-po in series, Sabvoton 72150 controller and Grin Cycle Analyst V3.
Current set-up I'm using Turnigy 10ah li-po packs, three 6s packs and one 4s pack. They're rated 12-24c discharge.
I have some Tattu li-po packs spare which are 10ah, same size packs, three 6s and one 4s. These are rated at 25c discharge.
My question is, would I be okay to connect these different brand packs in parallel, so I'd be running same voltage etc but with 20ah capacity? The reason I'm unsure is because they're different brand packs and I'm assuming have a slightly different internal resistance.
Any feedback appreciated.