LongRangeRider
1 µW
Hi All:
New member here.
Recently started to modify my stock e-bike.
I have swapped out the Bafang display and controller for the KT LCD8S and KT36/48SVPRL-ffF10AL.
I am running a cadence PAS with throttle; however, I would like to add a BB Torque sensor while keeping the throttle.
I once came upon a threat that discussed how to do this, but I cannot locate it again.
I believe that I needed to change the firmware, adjusted (drop) the operational voltage supply to the torque sensor, and solder in a new wire onto the controller at PIN X4.
After that, I cannot recall the finer details.
If anyone could point me in the right direction, you would make my upcoming biking season, better than the last.
Many Thanks,
LongRangeBiker
New member here.
Recently started to modify my stock e-bike.
I have swapped out the Bafang display and controller for the KT LCD8S and KT36/48SVPRL-ffF10AL.
I am running a cadence PAS with throttle; however, I would like to add a BB Torque sensor while keeping the throttle.
I once came upon a threat that discussed how to do this, but I cannot locate it again.
I believe that I needed to change the firmware, adjusted (drop) the operational voltage supply to the torque sensor, and solder in a new wire onto the controller at PIN X4.
After that, I cannot recall the finer details.
If anyone could point me in the right direction, you would make my upcoming biking season, better than the last.
Many Thanks,
LongRangeBiker