murphykr13
1 µW
so I have a phantom gogo r1 commuter I bought for my girlfriend. and have to replace the throttle. the replacement broke so now I am trying to wire a 3 wire throttle to it. I have a seperate push button. I am going to use for ignition, and a switch for headlight. the controller Is 450w 19a brushless controller and it has a 6 wire pinout going to throttle assembly. see pics. I have figured out part of the pinout
brown wire to headlight
white wire is battery voltage
Black wire goes to black on throttle
red I hope will go to red on throttle which leaves yellow and blue. I seem to remember the white yellow and blue were connected to the key ignition and I want to say on one side was blue and yellow and the other was white. i haven't been able to find the 5v signal wire with my multimeter. as of yet.either. thank you in advance.
brown wire to headlight
white wire is battery voltage
Black wire goes to black on throttle
red I hope will go to red on throttle which leaves yellow and blue. I seem to remember the white yellow and blue were connected to the key ignition and I want to say on one side was blue and yellow and the other was white. i haven't been able to find the 5v signal wire with my multimeter. as of yet.either. thank you in advance.