FilthyMutt
1 µW
- Joined
- Aug 17, 2022
- Messages
- 4
Hello to all. A few years back I purchased a MAC 8T kit from Paul at Em3ev. Was powerful and efficient given my choice of a 6 FET controller configured with 3077 FET's. Now, as is widely known, Paul/EM3ev no longer offers MAC kits. So I began searching out another source and happened upon Cutler MAC. Dealing with Shelley I purchased a MAC 8T hub and 12 FET ( 4110 ) controller for $700 CAD total. The controller complete with a Cycle Analyst connector. Upon installation and first use I found the setup to be underwhelming and inefficient. And I knew that the controller was programmable so I contacted Shelley and requested the necessary software ( given that the necessary programming cable was included with the controller ). And Shelley provided. And once extracted via 7-Zip we have >>>>>
1. INSTALL THE DRIVER
2. COPY SYSTEM32 ALL FILES TO YOUR WINDOWS/SYSTEM32 FOLDER
3. CHANGE REGSVR32.BA TO REGSVR32.BAT ,RUNNING REGSVR32.BAT AS ADMINISTRATOR
4. RUNNING GPM 8F.EXE ,OK!
Install the driver???
Sorry, but I'm totally unfamiliar with programming a controller and need assistance as to how to proceed.
I'm assuming that the stock settings have both Speed Limit and Current Limit set to low levels. And 'soft start' is enabled.
Settings that need changing in order to improve overall performance.
Thank you in advance for any/all assistance.
1. INSTALL THE DRIVER
2. COPY SYSTEM32 ALL FILES TO YOUR WINDOWS/SYSTEM32 FOLDER
3. CHANGE REGSVR32.BA TO REGSVR32.BAT ,RUNNING REGSVR32.BAT AS ADMINISTRATOR
4. RUNNING GPM 8F.EXE ,OK!
Install the driver???
Sorry, but I'm totally unfamiliar with programming a controller and need assistance as to how to proceed.
I'm assuming that the stock settings have both Speed Limit and Current Limit set to low levels. And 'soft start' is enabled.
Settings that need changing in order to improve overall performance.
Thank you in advance for any/all assistance.