Proper connector for hall sensor wires

[clealog15]

I can't figure out which connector (molex etc...) I need for the wires from the motor hall sensor.
My controller has a 6 pin molex connector for the hall sensor.

Here is a picture:

If the picture doesn't show up here is a link: https://imgur.com/a/axHRlfR

 

[docw009]

Picture doesn't show it, but there are 5 or six wires? Blue, yellow, purple, red, black amd maybe white.

That is the cable from motor? Those are pins that are inserted into a plug that matches your controller. Here's a motor cable. No, I do not know where to buy them. You could replace both sides with any arbitrary 6 pin connector, but it's better to use original.

 

[aroundqube]

Looks like you need the 6 pin white wire connector # CNX-54 here : http://www.electricscooterparts.com/whitewiringconnectors.html

 

[clealog15]

Thanks for the link aroundqube and for the picture docw009.

 

[docw009]

I needed one connector. I bought a box of them, because I'm always fiddling with an ebike motor.

https://www.ebay.com/itm/113226971237