Hello again,
I am getting a Kelly Controller with Cycle Analyst the day after tomorrow. I would like to test something with the Cycle Analyst. It is about the e-bike legislation in Germany.
I would like to use the full power of the motor for 25 minutes. After that, the maximum power should be gradually reduced to 350W (electric power, approx. 250W mechanical power). After 30 minutes, 350W should come out constantly from the accumulator.
Can I change the profiles via the serial interface? I would build a small controller which sends a command after 25 minutes and sets the system to the reduced power profile.
Alternatively, it would be fine if I could vary the maximum power over speed and never get over 350W at the test point of about 25km/h.
Thanks a lot for your ideas.
I am getting a Kelly Controller with Cycle Analyst the day after tomorrow. I would like to test something with the Cycle Analyst. It is about the e-bike legislation in Germany.
I would like to use the full power of the motor for 25 minutes. After that, the maximum power should be gradually reduced to 350W (electric power, approx. 250W mechanical power). After 30 minutes, 350W should come out constantly from the accumulator.
Can I change the profiles via the serial interface? I would build a small controller which sends a command after 25 minutes and sets the system to the reduced power profile.
Alternatively, it would be fine if I could vary the maximum power over speed and never get over 350W at the test point of about 25km/h.
Thanks a lot for your ideas.