so i drew too much current and blew broke some mosfets on my bms
I am planning to replacing the "5 fets even though 1 broke"
but as a side measure I am planning to replace it with a smart bms with blutooth and a switch support
the new bms is 2 wire not 3 wire
If i want tokeep the batteries hailong output and keep the xlr charging
Am i safe to assume all i need to do is combine P- and C- into 1 wire and keep the Original C+ as the connects to all same connection as P+
the B+ wire you see below is spare as my bms originally had B+ output and another B+ from the wires themselves they both go same spot
heres my proposed diagram
I am planning to replacing the "5 fets even though 1 broke"
but as a side measure I am planning to replace it with a smart bms with blutooth and a switch support
the new bms is 2 wire not 3 wire
If i want tokeep the batteries hailong output and keep the xlr charging
Am i safe to assume all i need to do is combine P- and C- into 1 wire and keep the Original C+ as the connects to all same connection as P+
the B+ wire you see below is spare as my bms originally had B+ output and another B+ from the wires themselves they both go same spot
heres my proposed diagram