ElectricGod
10 MW
dead thread
John in CR said:The disappointing part with them is when they went to thinner lams, the motors didn't get any better. Since then I've always visualized them as some Israelis using ultra-cheap labor Palistinians to wind their motors.
Now I remember your posts on the Revolt motors...not very thorough or detailed...
...This is far better copper fill in the 120-reg. There's still room for a bit more copper here, but I'd call this 80% full.
ElectricGod said:What outrunner would you use?
I do honest reviews...show the good and bad for the benefit of everyone. I've already said several things about the RV-100-reg and RV-120-reg that I don't like. I also point out things I LIKE about them. I'd do that for any review.
neptronix said:I've been trying to badger multiple manufacturers to sell me a DD with 0.27mm lams for use in a 20" bicycle wheel. Even offered to pay 100% of the R&D even if it means a single motor costs me 4x more than their retail price, just so that i can get a prototype and dyno it. No biters!