I am using a 72150 with a bafang BBSHD. With an ASI controllers, if you push the throttle gently, it will move the chainwheel slowly.
With the 72150, if you push the throttle gently, it will move it slowly until it hits a certain RPM, then it stops, then it starts, then it stops, then it starts. Every second it will have a pulse, then turn off, then turn on, then turn off. It's not a steady or consistent motion at all, it is somewhat nauseating.
I am wondering if this may have anything to do with how I've set it up. The throttle off voltage is 1.07v, so I set minimum throttle voltage to 1.17v. My battery can put out about 50 amps continuous, 60 amps peak DC current, and is a 52v.
I've tried messing with the throttle minimum and middle voltages, and the phase amps for throttle middle endlessly but can't seem to get it to stop pulsating at a ridiculous kind of rate of full power-no-power twice a second on low throttle.
Thank you!
With the 72150, if you push the throttle gently, it will move it slowly until it hits a certain RPM, then it stops, then it starts, then it stops, then it starts. Every second it will have a pulse, then turn off, then turn on, then turn off. It's not a steady or consistent motion at all, it is somewhat nauseating.
I am wondering if this may have anything to do with how I've set it up. The throttle off voltage is 1.07v, so I set minimum throttle voltage to 1.17v. My battery can put out about 50 amps continuous, 60 amps peak DC current, and is a 52v.
I've tried messing with the throttle minimum and middle voltages, and the phase amps for throttle middle endlessly but can't seem to get it to stop pulsating at a ridiculous kind of rate of full power-no-power twice a second on low throttle.
Thank you!