EDG123
10 µW
- Joined
- Jun 29, 2014
- Messages
- 5
Hi all,
I am trying to configure 2 Gen4 (type4) controllers working in master-slave mode to control a pair of ME1012 PMAC motors.
After uploading the .dcf file in the thread below, I have lost the ability to communicate with the controllers.
http://endless-sphere.com/forums/viewtopic.php?f=1&t=54186
The LED on the master controller stays solid green while the LED on the slave controller flashes briefly when power is first applied.
I get two green LEDs on the CAN converter
..and some data appearing in the CAN window
However when I try to use the DVT Helper, I get the following error -
Trying to login gives the following message -
Login failed. SDO write to 0x5000,2 returned Timeout
SDO write to 0x5000,2 returned Timeout
The Vehicle Interface still shows the status of gear switches and throttle position
Any help would be greatly appreciated
I am trying to configure 2 Gen4 (type4) controllers working in master-slave mode to control a pair of ME1012 PMAC motors.
After uploading the .dcf file in the thread below, I have lost the ability to communicate with the controllers.
http://endless-sphere.com/forums/viewtopic.php?f=1&t=54186
The LED on the master controller stays solid green while the LED on the slave controller flashes briefly when power is first applied.
I get two green LEDs on the CAN converter
..and some data appearing in the CAN window
However when I try to use the DVT Helper, I get the following error -
Trying to login gives the following message -
Login failed. SDO write to 0x5000,2 returned Timeout
SDO write to 0x5000,2 returned Timeout
The Vehicle Interface still shows the status of gear switches and throttle position
Any help would be greatly appreciated