........may I please ask for assistance (this thread seems semi-approprite?)
I am assembling my Surly Big Dummy with the following: Clyte HT3525, 72V Clyte motor controller, Headway 16AH pack (two 36V in series)...GOOD STUFF!
Anyways, got it all set up, and the wheel did spin for just one moment. I went to go get the wife and kids to show em, but it did not run again........(?) The wifey laughed her arrs off(!)
The DMM says both Headway packs are kick'n out 40 Volts, and the light comes on on the contorller. I seem to have good connections all round..... no smoke, flame, pop'd fuses, or explosions....... and I'm at a bit of a loss as to what to check of next....?
Do you have any suggestions as to what to check next?
I am assembling my Surly Big Dummy with the following: Clyte HT3525, 72V Clyte motor controller, Headway 16AH pack (two 36V in series)...GOOD STUFF!
Anyways, got it all set up, and the wheel did spin for just one moment. I went to go get the wife and kids to show em, but it did not run again........(?) The wifey laughed her arrs off(!)
The DMM says both Headway packs are kick'n out 40 Volts, and the light comes on on the contorller. I seem to have good connections all round..... no smoke, flame, pop'd fuses, or explosions....... and I'm at a bit of a loss as to what to check of next....?
Do you have any suggestions as to what to check next?