Hey all, I’m having trouble connecting my antbms controlled battery to my sabvoton. If I power up the discharge mosfets and connect the battery, there is a large spark and the bms short circuit protection is triggered. If I leave the wires connected and try to power up the discharge mosfet, the controller caps suck out the power and the bms precharge never succeeds. Can I place this 10w precharge resistor in between the positive wire like shown below? My idea is that I only need to hold it for a few seconds, allowing the controller to charge the caps and avoid the short circuit problem with the bms. I’ve read through previous threads about precharge but I want to confirm that this will work as a temporary solution?