Trampa Conversion -- Request

[readerror67]

Hello everyone,

I have been reading up on this for a while now. I finally bit the bullet and got a Trampa board ordered today. I built 3 VESC some months back and plan to go with the dual SK3 motors on it.

I was curious if anyone had drawings or dimensions for the Trampa hangers, I'm pretty sure I have enough aluminum here to get started on building out the mounts.

The setup I went with is: http://www.trampaboards.com/35-holypro-trampa-deck-on-ultimate-trucks-superstar-wheels--ratchet-bindings--728-black-mountainboard-p-11899.html
These are the hangers: http://www.trampaboards.com/ultimate-atb-hanger--9525mm-titanium-axles-anodised-black--cncd-light-p-11153.html

I am mostly trying to get the dimensions or drawings of the inner profile that connects to the hanger (will attach image, sourced from Squad's thread)

Any other drawings would be useful as well, anxious to start making chips

Thanks!

 

[Squad]

My mount has 23x23 mm square hole, fillet radius is 5 mm. The truck itself is 21,5 x 21,5 mm at the end but it gets a little bit thicker as You go near the middle of the hanger.

 

[Trampa]

Just send me a mail: frank@trampaboards.com

I have what you need.

Frank