Greetings! This is a great community and hope one of you have some insight.
I've bit the Bullitt and picked up my dream cargo bike! It's a 2017 Larry vs Harry which many in this forum have electrified to great success. I picked up a TSDZ2 kit, with @casainho OS software loaded, installed a temp sensor, and even swapped out the blue gear for a metal gear because I know the load is greater with myself, bike, kids, and cargo!
Essentially - I'm building my dream bike.... BUT
The motor does not fit without modification and I'm concerned that if I dremel or sand material off of the motor... it still may not fit!
I've added a number of pictures that show the motor pushed through as far as it will go clockwise and counter-clockwise and it's still not clear where I should remove material to make this work. If you folks have any suggestions... I'm all ears!
Thanks!
Counter-clockwise
Clockwise (sorry about rotated pic!)
I've bit the Bullitt and picked up my dream cargo bike! It's a 2017 Larry vs Harry which many in this forum have electrified to great success. I picked up a TSDZ2 kit, with @casainho OS software loaded, installed a temp sensor, and even swapped out the blue gear for a metal gear because I know the load is greater with myself, bike, kids, and cargo!
Essentially - I'm building my dream bike.... BUT
The motor does not fit without modification and I'm concerned that if I dremel or sand material off of the motor... it still may not fit!
I've added a number of pictures that show the motor pushed through as far as it will go clockwise and counter-clockwise and it's still not clear where I should remove material to make this work. If you folks have any suggestions... I'm all ears!
Thanks!
Counter-clockwise
Clockwise (sorry about rotated pic!)