Elinx said:The pedal cadence sensor is on the controller boardSYOTR said:.... measure pedal cadence. Is there some advantage to having more magnets?....
Imho there is no real advantage to add more spoke magnets for speed measuring. Theoretical the accuracy should be better, but practical I think you don't see the difference. On stock FW it was also possible to install more magnets.
The stock Tsdz2(B) has a very bad heat management. If you run the tsdz2 with 600W, the motor will heat up, with a chance on demagnetization of the bare motor.hermes127 said:... like to know what are the benefits of implementing it with a 48V TSDZ2B motor and VLCD5 display and if it's advisable to add it.
The first addition to reduce this chance, was adding a temperature sensor that powerdown the motor if the heat will go up.
The second addition was adding heatconductive material between bare motor and housing.
See wiki
See this thread
Both additions are effective and in your case I advice to add at least heatconductive material.
Thanks for your response and the links, I'm not using the stock firmware but the Open source firmware TSDZ2-v20.1C.2 in hybrid mode. Ok, so adding the sensor and heatconductive material is a good implementation.