bpratl
10 mW
New problem, "Brake error" after one year.
TSDZ2, 860C, OSF V20, 52V, 750 W with 3 wire hall brake sensors. Even after unplugging both sensors I still get this error after 30 seconds on start up. I can enter the configuration menu, and everything looks OK and on exit the display appears but there is no Voltage reading but shows 100% charged. I measure 58.6 volts at the battery but with this error the bike is disabled. Should there be 5 Volts or ground on the Signal wire when not using the brakes? What is the best method of testing the Hall sensor? Should the controller function OK with the brake sensors unplugged?
TSDZ2, 860C, OSF V20, 52V, 750 W with 3 wire hall brake sensors. Even after unplugging both sensors I still get this error after 30 seconds on start up. I can enter the configuration menu, and everything looks OK and on exit the display appears but there is no Voltage reading but shows 100% charged. I measure 58.6 volts at the battery but with this error the bike is disabled. Should there be 5 Volts or ground on the Signal wire when not using the brakes? What is the best method of testing the Hall sensor? Should the controller function OK with the brake sensors unplugged?