Success!...It works...I tried Keplers suggestion and moved the green signal wire to the new location...Not really bothered about not having PAS...
Thanks guys for your trying to help.
Next trick is to see if the controller can handle 48volts??
I bought 6 of these mini controllers cheap, without being told that they are Euro spec PAS only...I presume they have been modified for the European regulations...So how do I make it a throttle only controller???..
It has no throttle plug ...Only PAS.
It has been suggested it is a KU63 type,but...
I think you are right...the wires are probably for the PAS...When I spoke to the importer the other day he did say it was Euro compliant...
As I've said, he told me it could be used with the throttle if the PAS was set up in series...but as Amberwolf say's it doesn't make sense..I have not been...
Spoke to the importer this morning..(turns out you were right first time amberwolf)...This controller needs a pedal sensor (PAS)...
As the controller only has three little wires for the throttle,I had assumed that there was nowhere to plug in a PAS...The importer informed me that the PAS has to...
I had the same thought about the ebrakes... but unfortunately its not that...as for the power well above 31volts ...more like 41v
I'm beginning to think something is broken.
Bought a cheap 36v brushless geared motor...the supplier also sold me a cheapo brushless controller..He didn't know if the hall & phase wire colour codes matched up..I didn't think it would be a big issue..I tried the obvious and matched the colours..attached the throttle & power wires which...
wondering if the controller will take higher voltage without mods?...the wheel is a golden motor type brushless hub 36volt 700w...
The controller is a different layout to my previous GM controller, which I had modified using the zener diode in front of the large resistor trick...This controller...
I have seen cheap Chinese hall effect controller testers on ebay.. selling at only £14.79(around U.S.$23.00)....wonder if anyone has experience of them?..They look like the could take the headache out of matching controllers to motors.