Recent content by Golden2000

Motor with single hall sensor without board on it !!!

My controllers is lsw6g i use (hv5v , hvgnd , hv) pins for throttle but the controller doesn’t run , can I disable pas for use throttle ??

My battery give me on B+ and B- 37v , after bms give me 33v , i don’t know what i can check to resolve the problem

S Scooter wheel 48v

Anyone know what this pins for ??

I take it from broken ebike , so I don’t know if it was working or not …

Yes my friend … When i connect the battery it’s make a little spark and i check throttle voltage its give me a 4.9v and voltage increases on signal from 0.8 to 4.2v

Anyone …

i have a kt36 controller , I don’t need the lcd display i short gnd with rx as this wiring diagram, but it still not working, is there anything can i check to run it ??

I solved the problem by use the light 5v output instead throttle 5v , and worked very good

From another 5v source , throttle work very good , the problem with the controller throttle 5v output

From controller without throttle red and black 4.8v , when I connect throttle red and black wire voltage drop down to 2.6v , green wire .8v on release and 1.6 on full throttle

All you say correct The scooter didn’t drive at full speed , because the output voltage drop down to 2.6v not keep on 4.8v

My friend yes it’s rental (but after market) , i test it with output 5v and it work very good , but the voltage from control drop down from 4.8v without throttle to 2.6v when I connect the throttle , is there any way to add something resistor or capacitor or anything else to keep outputs voltage...