Search results

Date Relevance Most replies

  1. H

    Ebike, LightningRods Big block on a Klien frame. Toronto area

    mid drive motor made by Lightning Rods https://lightning-rods10.mybigcommerce.com/single-stage-big-block-middrive-rhd/ It is built on a Klien Frame. It has a Cycle Anylyst digital dashboard. All the parts are top of the line Peter pmistel@gmail.com $1500 CAD
  2. H

    Critique my Davinci Drive boat setup

    Hi I bought a Davinci Drive several years ago from the classifed section on this website. I tried mounting it in a bike but I could never get it setup properly so I gave up. I have been looking for a use for it so this is what I have come up with. I invite people to look at what I am doing...
  3. H

    Help identify this Crytalyte hub motor, is it worth fixing?

    I have an old ebike I am trying to fix. It has this Crystalyte hub motor on it. I cant get it to work so I took it apart and it looks like the wires going into the hub are damaged. I also measured the voltage to the hall sensors with the controller powered up, and I would get 5 volts...
  4. H

    Looking for BMS suggestions

    I have this Tesla module that has been reconfigured so that it is 12S37P. I need to add another string to it as I need more voltage for the boat motor I want to power. I had a 12s BMS but I need a 13s bms for the new configuration. I expect to draw as much as 100 amps powering the motor. Any...
  5. H

    I need a part for a davinci drive

    I have a davinci drive with an astro 3220 with a half inch shaft. I was going to use the motor in a different application and I ended up destroying the pulley on the motor taking it off. I now want to use the complete drive again so I need to get that pulley replaced. Does anyone know how to...
  6. H

    Battery for an outboard

    Hi I just bought a Briggs and Stratton Etek outboard on eBay. I don't have it yet but I want to get a head start on how I might power it. I have searched the internet for a manual but can't find anything. All I know is that it is 48v and draws about 80amps at full power. I assume it was...
  7. H

    Can I swap handlebar controls?

    Hi, I'm building a mid drive lightning rods kit. The front derailleur is no longer needed, but it happens to be on the left. I still need the rear derailleur, which is on the right where the throttle is. It would be nice if I could have the right derailleur on the left. The controls are...
  8. H

    Lithium for an RV

    HI Im looking for suggestions for a lithium battery pack for an rv trailer that will be used in film and tv production. The company I work for has several of these trailers and we use 6v golf carts batteries in packs of 4 or 8 and as you can imagine they add a lot of weight to the already...
  9. H

    How do I get the pulley off an Astro 3220?

    I'm trying to get the pulley off my davinci drive because I need more rpms for a boat motor. I took all the set screws out of course. I can get it to move a bit but I'm afraid I'm going to wreak my very expensive motor forcing it off. It's to the point where I may have wreak the pulley and I...
  10. H

    Davinci drive pulley question

    I have a davinci drive that I am using in a 5hp outboard motor. I have removed the gas engine and mounted the davinci drive in its place. My rough back of the envelope calculations make me think that the prop will be turning a bit slow. It would be nice to get some larger pulleys that fit on...
Back
Top