micart671
100 mW
Hi,
I have had a problem recently with two DD motors;
* Replaced a faulty hall sensor and motor runs rough with low torque (all wiring remains as original). I have connected my tester up and all hall sensors/motor windings function correctly.
I have tried different combinations of wiring but no luck and used a different controller set up too.
* Re-wired a damaged wiring loom due to an accident. All wiring as original and tests OK but runs the same as first motor (roughly with low torque). I suspected motor poling due to bent axle, but not the case.
I'm suspecting i now have the opposite of magic fingers and everything i touch turns to shit haha.
Any help will of course be greatly appreciated,
cheers,
Mic
I have had a problem recently with two DD motors;
* Replaced a faulty hall sensor and motor runs rough with low torque (all wiring remains as original). I have connected my tester up and all hall sensors/motor windings function correctly.
I have tried different combinations of wiring but no luck and used a different controller set up too.
* Re-wired a damaged wiring loom due to an accident. All wiring as original and tests OK but runs the same as first motor (roughly with low torque). I suspected motor poling due to bent axle, but not the case.
I'm suspecting i now have the opposite of magic fingers and everything i touch turns to shit haha.
Any help will of course be greatly appreciated,
cheers,
Mic