Kingnothing71us
10 µW
Hi everyone, I need some help very badly.
I have a Hidoes B6 E-bike and I was messing around in the perimeters and accidentally set a pass code and turned it on. I didn’t have a manual for the display which is a Yolin YL91F-V, it has a 6 pin Julet connector.
I ordered a replacement screen from AliExpress.
When I received it and plugged it in and tried to turn it on, nothing happened.
Can anyone help me with an answer to this question-if I were to cut the connector off my locked display, would there be a way to match the wires from the new display to my 6pin connector and what are my chances of it working that way.
The wiring on my bike consist of PAS wires, power wires, tail light wires, rear hub motor phase wires and a 6 pin julet wire, I can post pics in the morning of the controller.
If I cut the wires I’ll be out of my $103 refund. I want to make sure I have a good chance to get it working before cutting anything.
I appreciate any help I can get. Thanks in advance.
I have a Hidoes B6 E-bike and I was messing around in the perimeters and accidentally set a pass code and turned it on. I didn’t have a manual for the display which is a Yolin YL91F-V, it has a 6 pin Julet connector.
I ordered a replacement screen from AliExpress.
When I received it and plugged it in and tried to turn it on, nothing happened.
Can anyone help me with an answer to this question-if I were to cut the connector off my locked display, would there be a way to match the wires from the new display to my 6pin connector and what are my chances of it working that way.
The wiring on my bike consist of PAS wires, power wires, tail light wires, rear hub motor phase wires and a 6 pin julet wire, I can post pics in the morning of the controller.
If I cut the wires I’ll be out of my $103 refund. I want to make sure I have a good chance to get it working before cutting anything.
I appreciate any help I can get. Thanks in advance.