Looking for Bafang motor cable.

[alfgar]

Hi, I recently got a good deal a Rize Liberty e-bike with a 48v bafang G062. 750 watt hub motor that needs the cable replaced because it's ripped.

Not sure why but I cannot seem to find where to buy the motor cable. Found the following but it’s to short for me.

https://ebikes.ca/l1019-m.html

I would appreciate help in finding somewhere to buy a cable.

Side note: The seller told me it was a 750W but once apart, the hub is stamped 1000W. Not sure how to interpret that?


Thanks in advance

 

[TuomasK]

There is L1019 extension cable available from Grin too. Its 60cm in length so you can cut and use the length desired. https://ebikes.ca/l10-ext.html

I have bought L10 and other cables from e-bike technologies but Im based in EU.
https://www.e-bike-technologies.de/index.php/en/connectors/connectors-motor/higo-l1019-series/higo-l1019-m-s-detail

 

[alfgar]

Thank you very much. Really appreciate it. Waiting on anther source but I believe I will end up getting this one after all.

Two questions if I may.

1 - was it tight to pull through the shaft? Any major issues?

2 - in your pic, it looks like the small green and yellow wires are reverse from mine? I haven't really snipped and looked closely at mine in detail yet. But in the pics, they looked reversed.

thanks again.

 

[TuomasK]

Thank you very much. Really appreciate it. Waiting on anther source but I believe I will end up getting this one after all.

Two questions if I may.

1 - was it tight to pull through the shaft? Any major issues?

2 - in your pic, it looks like the small green and yellow wires are reverse from mine? I haven't really snipped and looked closely at mine in detail yet. But in the pics, they looked reversed.

thanks again.

1. Not too tight. In fact I also added two thin extra wires for temp sensor.
2. I've seen the motor cable colors or mapping may vary. Best to check pcb tab to connector pin

 

[alfgar]

great. thanks again/