I have a Matsui 1000w hub motor that came with my Ariel rider xclass 52v. I'm upgrading the controller and instead of cutting the higo connector on the motor I want to add a 10 pin higo connector to the new controller.
I just have not been able to find a pinout for the motor and not sure how I could test without have the motor open. My biggest concern is getting the 5v and neg in the wrong place and frying something.
Anyone have any tips to figure this out?
I was thinking of opening the controller and testing from there but I'm not sure if I want to chance that either. It's not the common KT type controller and looks a little harder to get into.
Thanks for any assistance.
I just have not been able to find a pinout for the motor and not sure how I could test without have the motor open. My biggest concern is getting the 5v and neg in the wrong place and frying something.
Anyone have any tips to figure this out?
I was thinking of opening the controller and testing from there but I'm not sure if I want to chance that either. It's not the common KT type controller and looks a little harder to get into.
Thanks for any assistance.