Emoto said:
Ok fellas thanks, Ill know in a few days If i get a kls..... And ill run it with the android app first and evaluate its usefulness , as said before logging would be a good idea .
1,Bluetooth function is available on KLS/KAC/KPM controller.Customers just need to buy bluetooth converter from Kelly website.
KAC is used for AC induction motor controller with encoder.
KPM is designed for brushed PM motor.
2,Three speed function is available on KLS controller also.Right now it is not released in the standard version.But customers need this function,we can add it.Just leave the comment in the order list or send email to me before ordering.
Three speed function will use pin9,pin12 and pin11.So original function on pin9 will be removed.Pin9 will be used as low speed function.
Pin12 is forward direction function.The three speed function can be enabled in the user program.When you enable three speed function,pin12 is used as high speed function.
You can configure different speed rating for low,medium and high speed mode.
We will release the new version for KLS controller which will include the three speed function and eliminate RLY driver function by default.
3,We sold KLS controllers for over 1.5 years.So I had experienced with more examples about the auto identification with different motors.
The motor has good or had quality from different suppliers.Some motors are very good.It can do the ID operation quickly.
Some other motors may not be balanced well.There is a big deflection or tolerance between hall and phase timing.So it can not finish the ID operation.
I did get this experience with some customers' motor.
Some customers adjusted the hall sensors position so that the waveform can match with each other well.The motor can be drived again.
If you have the OSC device,please try to capture the waveform of hall/phase timing.
We will know if there is a big tolerance between hall waveform and phase timing waveform.
4,CAN bus is broadcast type on KLS-D/H/8080I controller.
We included the protocol of broadcast CAN bus in the user manuals.
But CAN bus need an external PCB Board inside the controller.KLS-S has small room inside.We can not add CAN bus function on KLS-S model.
So there is no choice to add CAN bus on KLS-S when you order this controller.
The broadcast CAN bus is only available for KLS-D/H/8080I controller.The CAN bus is optional function for KLS-D/H.If customers don't pay it,we will not add this CAN bus board.
The KLS-8080I/8080IPS included the CAN bus by default.Because KLS-8080I/IPS is very huge.And CAN bus board came with the whole PCB board.
The broadCast CAN bus means the controller will send all the messages per 50ms.You don't have to send any commands and ask for response.
This CAN protocol is a little different from the CAN function on other KBL,KHB controllers.
5,KLS-D/8080I/IPS included the fuse and shunt by default on the top of case.
KLS-S doesn't include fuse or shunt by default.
The KLS-H can include fuse or shunt.By default,it includes the fuse.
So it is better to use KLS/D/H/8080I/IPS controller for CA.
And KLS-8080I/IPS controller is isolated type.The CA is not.The signal from CA may not used to try to control the motor speed or torque.