Jeremy, this is awesome stuff, thanks allot for sharing.
I was thinking of a adapting this idea to something simpler (hopefully , I could be wrong on that part).
Instead of running the "mains" power up to this circuit for switching it on/off I could just run my throttle signal through here, just killing of the throttle.
How much current can I pull from the 5v on the throttle line? I have a Lyen 12 fet controller and a cycle analyst connected. Could this power the RFID module, PICAXE chip and any switching needed to pull the throttle down? Just from the 5v in the throttle line?
Any tips on adapting this design to what I describe above?
I was thinking of a adapting this idea to something simpler (hopefully , I could be wrong on that part).
Instead of running the "mains" power up to this circuit for switching it on/off I could just run my throttle signal through here, just killing of the throttle.
How much current can I pull from the 5v on the throttle line? I have a Lyen 12 fet controller and a cycle analyst connected. Could this power the RFID module, PICAXE chip and any switching needed to pull the throttle down? Just from the 5v in the throttle line?
Any tips on adapting this design to what I describe above?