Fodterapeuten
1 µW
- Joined
- May 21, 2018
- Messages
- 1
Hi every one.
I have a Riese & Müller Load with Nuvinci N380 stepless gear hub and 2 pcs 500watt batteries mounted.
Its a Bosch Performance CX center motor. With Bosch nylon display.
I often think I give it so much gas that the tallest gear is too low and I roll around (too high cadence) I can not gain more speed.
Are there anyone who have an idea of what to do so it gets tougher at the top so I do not get that high cadence and thus can not drive as fast as I would like.?
I'm thinking about changeing the chain rings in the front and in the back to higher teeth. Can somebody explain to me what will happend if i go up in teeth in chain rings in the front and in the back?.
I have a Riese & Müller Load with Nuvinci N380 stepless gear hub and 2 pcs 500watt batteries mounted.
Its a Bosch Performance CX center motor. With Bosch nylon display.
I often think I give it so much gas that the tallest gear is too low and I roll around (too high cadence) I can not gain more speed.
Are there anyone who have an idea of what to do so it gets tougher at the top so I do not get that high cadence and thus can not drive as fast as I would like.?
I'm thinking about changeing the chain rings in the front and in the back to higher teeth. Can somebody explain to me what will happend if i go up in teeth in chain rings in the front and in the back?.