Hi all
I have a Kelly KLS7218S controller with 72v battery pack & MXUS 3k hub motor.
I am using the supplied usb/rs232 cable between the controller & laptop but I keep getting the error ‘no power to controller or usb has been unplugged’
I have power connected to the main + & - wires, phase, throttle & hall wires are connected & power to the pink pin 7 power wire.
The red led is flashing a 3,4 sequence (angle sensor error) but as I haven’t configured it I guess that’s to be expected. If I rotate the wheels slowly the red led stops flashing & I get a solid green.
Any advice on how I can get the controller to communicate with the laptop would be gratefully appreciated!
I have a Kelly KLS7218S controller with 72v battery pack & MXUS 3k hub motor.
I am using the supplied usb/rs232 cable between the controller & laptop but I keep getting the error ‘no power to controller or usb has been unplugged’
I have power connected to the main + & - wires, phase, throttle & hall wires are connected & power to the pink pin 7 power wire.
The red led is flashing a 3,4 sequence (angle sensor error) but as I haven’t configured it I guess that’s to be expected. If I rotate the wheels slowly the red led stops flashing & I get a solid green.
Any advice on how I can get the controller to communicate with the laptop would be gratefully appreciated!